There is a growing need to assess the capacity of precast concrete systems in order to ensure equivalent structural capacity comparable to monolithic structures. In this study, experiments were conducted on reinforced concrete (RC) ordinary shear walls with various aspect ratios, and the results were analyzed to determine their limiting drifts. Four ordinary shear walls with identical sectional detail were tested by applying lateral loads at the top to simulate a prepared displacement history. The test results revealed that all specimens exhibited flexural behavior and showed buckling of the main bars around the compression end at the final stage. Regardless of the aspect ratio, all specimens reached their maximum load capacity at a drift ratio of about 1.0 %. At the failure state (reaching 0.8P_u at the third cycle), the drift ratio of each specimen varied from 1.44 to 2.1 % in proportion to the aspect ratio, up to a h_w/l_w of 2.0. The nominal strength calculated according to the Korean design code showed good agreement with the experimental results. Based on the analysis of the experimental findings, a limiting drift for RC ordinary walls was defined to facilitate emulative evaluation, following the same procedure used for special shear walls in ACI 550.6-19. By using the proposed limiting drift, it becomes possible to emulatively evaluate the precast intermediate walls corresponding to the RC ordinary shear walls.
최근 국내에서는 프리캐스트 콘크리트 구조가 일체식 구조와 동등한 구조적 능력을 확보할 수 있는지에 대한 성능평가의 필요성이 대두되고 있다. 이에 따라, 본 연구에서는 다양한 형상비를 갖는 RC 보통 전단벽에 대하여 실험을 실시하고 그 결과를 분석하여 한계 변위비를 제시하였다. 단면 상세가 동일한 4개의 보통 전단벽체를 제작하고 준비된 변위 이력에 해당하는 횡하중을 가하여 실험을 실시하였다. 실험결과, 모든 실험체는 휨에 의해 전체적인 거동이 지배되었으며, 최종파괴는 공통적으로 압축단에서 최외단의 주근이 좌굴되는 양상을 보였다. 형상비와 상관없이, 모든 실험체는 약 1.0 %의 변위비에서 최대하중에 도달하였다. 파괴 상태(세번째 싸이클이 최대하중의 80 %에 도달)에 도달 시, 각 실험체의 변위비는 형상비 1.0에서 2.0까지 비례하여 1.44~2.1 %의 범위를 보였다. 국내 구조기준에 따라 산정된 공칭강도는 실험결과와 좋은 대응을 보였다. 실험결과의 분석을 통하여 ACI 550.6-19의 특수전단벽에 대한 절차와 동일한 방법으로 RC 보통전단벽의 동등성평가를 위한 한계 변위비를 정의하였다. 제안된 한계 변위비를 이용하여, RC 보통전단벽에 대응되는 PC 중간벽체의 동등성평가를 할 수 있다.