Precast concrete (PC) buildings with wall system are constructed by stacking wall panels and floor slabs, which are typically connectedthrough grouted vertical and horizontal joints. The strength and deformability of vertical joints between PC wall panels play a crucial role inensuring the integrity of PC wall-type structures. This study presents the test results on the shear performance of vertical joints that weregrouted with concrete and reinforced with overlapping U-shaped (loop) bars. Four jointed PC wall panels were constructed and tested undermonotonic and cyclic shear loading. Each specimen consists of two PC wall panels, assembled with 170 mm vertical joint and loop barsalong the height for casting joint mortar. The deformed bars of 10 and 13 mm were utilized as U-shaped loop bars within the vertical joints. Direct shear tests showed that under monotonic loading, a specimen VJ-10M with 10 mm U-shaped bars exhibited more ductile shear-slipresponse than the specimen VJ-13M with 13 mm U-shaped bars while the shear strength of VJ13-M is 16 % higher than VJ-10M. BothVJ-10M and –13M specimens show higher shear strength and greater ductility than VJ-10C and –13C specimens loaded under cyclic shear. Furthermore, this study evaluated the existing empirical and shear friction design formulas by comparing predicted strength and measuredstrength of 192 vertical joint specimens from this study and available literatures.
프리캐스트 콘크리트(PC) 벽식구조 건축물은 일반적으로 그라우팅된 수직 및 수평 접합부로 연결되는 벽체 패널과 바닥 슬래브를 적층하여 시공한다. 특히, PC벽체 수직접합부의 강도와 변형성능은 PC 벽식구조 건축물의 구조성능을 제어한다. 이 논문은 콘크리트 모르타르와 겹침이음된 U자형(루프) 철근으로 보강된 수직 접합부의 전단 성능에 대한 시험 결과를 제시한다. PC벽판 수직접합부 4개 실험체에 대하여 단조 및 반복재하 실험이 수행되었다. 실험체는 200mm 두께의 PC 벽체 2개로 구성되며, 수직접합부의 U자형 철근은 10mm와 13mm 이형철근이 사용되었다. PC벽판 수직접합부에 대한 대한 실험결과, 단조재하된 10mm U형 연결철근으로 보강된 수직접합부 실험체(VJ-10M)는 반복재하된 실험체(VJ-10C)에 비하여 연성적인 거동을 보였다. 13mm U형 연결철근으로 보강된 수직접합부 실험체도 유사한 경향을 보였다. 기존 국내외 설계기준식 및 제안식의 적합성을 평가하기 위하여 총 192개 실험체에 대한 실험결과와 계산결과의 비를 산정하였고 이를 근거로 볼때, ACI(KDS) 설계기준식 및 Seo의 제안식이 신뢰성이 높은 것으로 평가되었다.