Biogas utilization is one of the most promising options for reducing the consumption of fossil fuels for energy production, but the presence of H 2 S represents a serious industrial and environmental problem. In this work, two different synthesis methods (sol-gel and incipient wetness impregnation) were used to synthesize iron oxide supported on silica catalysts (Fe 2 O 3 /SiO 2) with metal loadings ranging from 0.5 to 10 %wt. The catalysts were tested for the selective oxidation of H 2 S, changing the operating conditions like O 2 /H 2 S (0.5–2.5), temperature (170–250°C), and water content (0–50%). The optimum condition was O 2 /H 2 S = 0.5 and no water at 230 °C with the conversion of approximately 100%, the selectivity of 97%, and the deactivation of 0.6%. A detailed characterization of the fresh and spent catalysts' surface revealed the presence of four deactivation mechanisms: metal surface reduction, oxygen vacancy loss, pore plugging, and sintering. Among the observed deactivation mechanisms, the sintering showed the highest impact on catalytic activity and deactivation. The sol-gel catalysts (SG) showed the highest metal-oxide/support interaction, which reduced the metal-oxide nanoparticles sintering compared with the incipient wetness impregnation method (IWI), reporting a lower sintering, higher activity, and selectivity, lower deactivation rates and lower sensitivity to the operating conditions. A catalytic cycle representing the possible surface intermediate states of the catalyst is proposed based on the performance and characterization results obtained. • The strong metal-support interaction increased the stability of the catalysts. • The sol-gel catalysts' activity showed lower sensitivity to the operating conditions. • Four deactivation mechanisms were found in the H 2 S selective oxidation. • The major deactivation mechanism was the sintering of the active phase. [ABSTRACT FROM AUTHOR]