A computational study on the fire in compartment rooms which are connected in serial have been carried out. The central room and two neighbouring rooms exchange gases through openings and the fire takes place at the bottom of central room. The positions of the openings and the height of the source zone in VHMS(volumetric heat mass source) model were considered as the prime parameters affecting the characteristics of fire. The results indicate that the reverse flow is found around openings after the fire takes place. The developing of reverse flow is earlier in inner openings which locate between the burning room and neighboring rooms. The reverse flow is important because it supplies oxygen to the fire, so that it can enhances fire. The position of the opening affects on the beginning of the reverse flow. The developing of reverse flow is earlier in the case of upper openings. As the opening goes down to low position, the developing of reverse flow is delayed. Therefore, the arrangement of openings to lower position can improve the fire safety. The temperature of the ceiling above the fire increases as the height of source zone increases in initial stage. But it is changed to decrease for the taller source zone. The critical height of source zone is found between this increasing and decreasing tendency of temperature. It means that the temperature is affected by the choice of the height of source zone. Therefore, in using the VHMS model, the choice of the height of source zone should take this tendency into account.
서로 연결되어 있고 개구부를 통해 가스를 교환할 수 있는 방들의 화재를 전산해석을 통해 연구하였다. 해석에는 직렬로 연결된 3개의 방을 기본 모델로 사용하였고 화재는 가운데 방의 바닥 중심에서 발생한다고 가정하였다. 이 방들에는 방끼리 연결하는 내부 개구부와 외부로 개방된 외부 개구부가 각각 존재한다. 개구부의 위치는 천장부근과 벽의 중간 및 바닥 부근으로 변화시키고 이 같은 변화가 화염으로부터 발생한 열과 연소 가스의 전파에 미치는 영향을 파악하였다. 전산해석에는 열질량체적생성(VHMS) 모델이 사용되었는데 모델 사용에 있어 생성영역의 높이가 계산결과에 미치는 영향에 대해서도 검토하였다. 해석결과, 화재가 발생하게 되면 개구부를 통해 실내로 역류하는 유동이 나타났는데 이 같은 역류 현상은 방과 방을 연결하는 내부 개구부에서 먼저 시작되고 외부로 개방된 외부 개구부에서는 늦게 나타났다. 또한 개구부 위치가 천장에 가까우면 역류 현상은 빠르게 나타나고 바닥에 가까우면 늦게 나타났다. 역류 현상은 화염에 산소를 공급하는 원인이 되므로 화재의 확산을 지연시키기 위해서는 개구부를 낮게 설치하는 것이 좋다고 판단된다. 또한, 생성영역의 높이가 높아질수록 화염 위의 천장 온도는 점차 높아지다가 일정 높이 이후에는 감소하는 경향을 나타내었다. 따라서 열질량체적생성 모델 사용시는 이 같은 점을 고려하여 생성영역의 높이를 정하는 것이 필요하다고 판단되었다.